Fevicol SH

Brand : Pidilite

Fevicol SH has years of trust and durability which is unmatched by any other adhesive in the country.
It is an excellent adhesive for pasting wood, laminate, MDF, Particleboard. It is easy to apply and use.

FIELD OF APPLICATION
Furniture Industries
Bonding laminate, plywood, veneer, particleboard, MDF, block board, hard
board to each other.
Non-furniture Industries
Bus body building where wood is used

APPLICATION METHOD
Surfaces to be bonded should be free from oil; grease; dust and dirt and should
be dry and properly levelled.
For best results, roughen the surfaces to be bonded.
Stir content of container before use.
Apply even coats of FEVICOL SH first on comparatively non-porous surface, and
then on porous surface for e.g. apply first on laminate and then on plywood.
If possible, application should be lengthwise on one surface and breadth-wise
on other surface. This will help in proper and uniform spreading of adhesive
while pressing.
Before allowing adhesive to dry, bring both the surfaces in contact, make proper
alignment, and start pressing from one side by using wet squeezed cloth to
avoid bubbles, and ensuring uniform contact.

PRECAUTIONS
When not in use, container should be kept closed.
Skin formation if any, should be removed from the surface before use.

SHELF LIFE
Best to use before 24 months from the date of manufacturing.

STORAGE
Store in cool & dark shaded place; away from the sunlight

Pressure can be given by using nails; clamps; weight; masking tape etc.
Excess adhesive; which oozes out from edges should be wiped off with wet
squeezed cloth.
To get best results, bonded surfaces are to be kept under pressure for 24 hrs.
If required, pressure can be released after 4-6 hrs and the bonded assembly can
be put to use. In case of highly porous surfaces like particleboard and MDF, it is
advised that, a thin coat of FEVICOL SH is applied by pressure on the surface
and allowed to dry. This will fill the pores of the surface. After drying, light
sanding is to be done for getting smooth leveled surface and then this surface is
bonded as per the method shown above

ADVANTAGES
Solvent free, Non-hazardous, Non-flammable, No fire hazards.
Free from offensive smell.
If required it can be diluted with clean water till applicability is achieved.
Very quick setting time. Handling strength is achieved within 6-8 hrs of
application.
Superior flow and spreadability and hence it can give higher coverage.
Excellent bond strength offering better moisture resistance.
Heat resistance in normal case
Can be applied by brush, roller, spreader, fingertip OR any suitable applicator.
Easy to clean up while wet.
Excellent film formation.
Dries clear